Arctic introduces PX-1 thermal putty pads for easier GPU servicing
Arctic has unveiled the PX-1 series, a new category of thermal interface material designed to bridge the gap between traditional thermal pads and moldable putty. By combining the adaptability of putty with the structured application of pads, the PX-1 and PX-1 Extreme aim to simplify the often tedious process of servicing graphics cards and other complex PC hardware.
Replacing thermal pads on a graphics card is notoriously difficult due to the precision required. Users must find the exact thickness for various components, and even then, pads can deform under the pressure of the cooler, making it hard to replicate the original setup. Arctic’s PX-1 series attempts to solve this by offering a soft, clay-like material that conforms to varying component heights and uneven surfaces without the need for precise measurements.
Adaptability and Material Properties
The standard PX-1 is designed for widespread use across components like VRAM, VRM arrays, MOSFETs, and choke cooling. It features a 60% elongation ratio, allowing the material to stretch up to 1.6 times its original length before tearing. This high flexibility ensures consistent thermal contact even in complex layouts where traditional pads might fail to bridge gaps effectively.
For more demanding thermal environments, Arctic offers the PX-1 Extreme. This version features a firmer, high-density composition infused with artificial diamond powder to enhance heat transfer. While the standard PX-1 is highly moldable, the Extreme version has a lower 15% elongation ratio, making its consistency more comparable to a traditional thermal pad. It is also thinner, measuring 74 x 39 x 1mm.

Application and Pricing
Each box of PX-1 contains approximately 79g of material, distributed in five 1.5mm-thick pieces (74 x 39mm each). According to Arctic, this amount is sufficient to upgrade a flagship GPU like the RTX 5090 or up to five PlayStation 5 consoles. Both the standard and Extreme versions include a dedicated application kit to assist with precise placement.
It is important to note that these putty pads are not intended to replace traditional thermal grease or phase-change materials (PTM) for CPU or GPU cores. For those critical contact points, ceramic-based pastes like Arctic MX-7 remain the recommended solution. The PX-1 series is specifically targeted at large-scale application on secondary components to reduce waste and cost compared to bulk putty.

The PX-1 and PX-1 Extreme will be available through Amazon, eBay, and selected partners. Pricing is set at $25.99 (€34.99) for the standard version and $67.99 (€102.99) for the Extreme version, with MSRPs listed at $39.49 and $115.49, respectively.